This is the Futaba 7C 2.4GHz Helicopter Radio System with the R617FS FASST 7-Channel Receiver, and four S3001 Standard Ball Bearing Servos.
This is the helicopter version which will default to heli settings when powered up and does not have a ratcheted throttle stick.
Modeler can change from the default mode (mode 2 in USA) by holding the Mode and End keys and then turning transmitter On to access the STK feature, changing mode and turning transmitter Off and then On again.
It is recommended to send transmitter to the Futaba Service Center to change switch operation.
FEATURES: Futaba's FASST (Futaba Advanced Spread Spectrum Technology) shifts very quickly virtually eliminating signal conficts and interruptions unlike other 2.4GHz systems that only stay on one or two frequencies
Dual antenna diversity enables FASST system to automatically and seamlessly select the best reception between the two antennas built into the receiver ensuring that the aircraft stays under constant control of transmitter regardless of altitude
Newly designed Dial-N-Key jog dial with joy stick button allows cursor movement in four directions for very user friendly navigating through menus and programming
INCLUDES: Futaba 7C 2.4GHz Transmitter
R617FS FASST 7-Ch Receiver (FUTL7627)
NR-4RB 1000mAh 4.8V NiCd Receiver Battery (FUTM1380)
FBC-19B(4) 120V Battery Charger (FUTM1830)
Four S3001 Standard Ball Bearing Servos (FUTM0029)
NT8S600B 600mAh 9.6V NiCd Transmitter Battery (FUTM1457)
Switch Harness w/Charge Cord (FUTM4370)
Black Transmitter Neck Strap (FUTM5690)
Servo mounting hardware and instruction manual
SPECS: 7C 2.4GHz Transmitter
Current Drain: 170mA
R617FS FASST Receiver
Size: 1.6 x 1.1 x .35" (40 x 27 x 9mm)
Power Requirement: 4.8 - 6V
Current Drain: 80mA (at no signal)
Weight: 0.34oz (9.8g) with case, 0.25oz (7g) without case
S3001 Standard Ball Bearing Servo
Length: 1.6" (41mm)
Width: .8" (20mm)
Height: 1.4" (35mm)
Weight: 1.6oz (45.1g)
Torque: 33.3 oz-in at 4.8V 41.6 oz-in. at 6V
Transit: .23 sec/60¦ @ 4.8V, .19 sec/60¦ @ 6V

COMMENTS: The 7C 2.4GHz System is available in the following configurations;
FUTK7000 Airplane Version w/4-S3152 Digital High-Torque Servos
FUTK7001 Heli Version w/4-S3152 Digital High-Torque Servos
FUTK7002 Airplane Version w/4-S3004 Standard Servos
FUTK7003 Heli Version w/4-S3001 Ball Bearing Servos
FUTK7004 Airplane version with no servos
FUTK7005 Heli version with no servos
*All include R617FS Receiver