This is the 1/8 scale glow powered, radio controlled, Ofna Jammin X1CR off-road ready to run buggy.
FEATURES: Chassis: 3mm thick anodized aluminum with front and rear braces
Drive: Four wheel shaft drive
Engine: Ofna Force .26 with glow plug, foam air filter and shaft starter
Exhaust: Polished tuned pipe with header
Fuel Tank: low profile, with flip top cap and splash guard, tank is centered on chassis for improved handling
Radio: 2-channel Ofna AM pistol grip transmitter with two SX-0001 servos and RX-0001 2-channel receiver (27MHz) Fail safe unit returns throttle servo to netural if signal is lost
Clutch: 3-shoe clutch
Transmission: single speed with a 13 tooth clutch bell
Ball Bearings: full ball bearings included
Shocks: Four oil-filled, threaded body hard anodized aluminum, with 3.5mm diameter shafts and 7075 aluminum shock towers
Main Gear: 48 tooth, metal
Gearbox: Sealed front and rear
Differentials: Bevel gear
Brakes: Dual disk
Tires: Jammin Rippers round knob pattern (#80020 we don't stock) Wheels: White 1-piece, dish
Body: Highly detailed pre-painted lexan buggy style Suspension: 4 wheel independent
Camber Tie Rods: Adjustable, camber refers to the angle that the wheels sit vertically
Steering Tie Rods: Adjustable, caster/toe-in refers to the angle that the wheels point inward as viewwed from above
Steering: Bell-crank type with laydown steering servo Servo Saver: Included
Starting system: hand held shaft start (powered by a 6-cell battery) 5-cell hump receiver battery and 120mah wall charger Front universals and rear dog bones (dog bone style center shafts) Packaged in it's own nylon carrying bag
INCLUDES: One Ofna Jammin' X1CR nitro buggy with Force .26 engine, glow plug, polished tuned pipe, radio, pre-painted buggy body, D-Cell glow plug heater, 5-cell receiver pack, receiver battery charger, 250cc fuel bottle, hand held shaft starting system, decal sheet, wheels, tires (pre-mounted), and instructions
REQUIRES: Misc. Items: building and track equipment, one D-size battery for the glow heater, 6-cell battery and charger for the shaft start system, glow plug wrench, and eight AA batteries for the transmitter Fuel: 2-cycle glow fuel with 10%-15% nitromethane, 16% lubricant- Most of the fuels we carry meet or exceed the lubricant content required for optimum performance and maximum engine life. In the past, the conventional lubricant content used in fuel was 18%. But with new advanced technologies, fuels like Red Alert and O'Donnell for example, have a better quality of lubricants even though the percentages of lubricant content are lower. These high-tech lubricants provide exceptional cooling and protection.
SPECS: Vehicle-
Length: 15.75" (400mm)
Width: 8" (203mm)
Height: 5.25" (133mm)
Weight: Not listed
Wheelbase: 13.1" (332mm)
Tread- Front- 10.25" (260mm) Rear- 10.25" (260mm)
Front Track: 12" (304mm)
Rear Track: 12" (304mm)
Ground Clearance: 1.25" (31.75mm)
Body-
Length: 14.25" (361mm)
Width: 8.25" (209mm)
Height: 4" (101mm)

COMMENTS: For Replacement Ball Bearings use:
Qty. Size Location Bearing Set Qty.
6 8x16mm Front, Rear & Center Diffs DTXC1585 - 3
4 8x16mm Front and Rear gear boxes DTXC1585 - 3
2 8x16mm Front Knuckles DTXC1585 - 1
2 8x16mm Rear Hubs DTXC1585 - 1
2 5x10mm Clutch Bell DTXC1535 - 1
To replace the bushings in the bellcrank set up order these bearings 2 4x8mm flanged bearings (DTXC1517) x 1 package and 4 6x10mm bearings (DTXC1561) x 2 packages.
It is not possible to choose the channel you want on the radio as they are supplied to us from Ofna randomly with no indication of channel number.