This is the 1/8 scale, glow powered, radio controlled, Hot Bodies off-road D8 Buggy Kit.
FEATURES: Chassis: 0.16" (4mm) thick 7075 aluminum with one-piece engine mount and radio tray
Drive: Four wheel shaft drive
Fuel Tank: Plastic with flip top cap
Air Filter: Foam low profile design
Clutch: 3 shoe
Clutch Bell: 16 tooth steel
Transmission: Single speed
Ball Bearings: Full set
Shocks: Four oil-filled, 16mm big bore aluminum bodied
Main Gear: 48 tooth
Gearboxes: Sealed
Differentials: Planetary
Brakes: Dual disc
Wheels: Yellow plastic dish wheels, 3.2" (82mm) diameter, 1.6" (40mm) wide, 17mm hex
Body: Clear untrimmed buggy body
Bumpers: Front hardened plastic
Suspension: Hardened plastic arms with captured hinge pins Caster: Adjustable, caster/toe-in refers to the angle of the front suspension when viewed from the side of the car in relation to the chassis
Camber: Adjustable, camber refers to the angle of the tops of the tires from vertical when viewed from front or behind vehicle
Steering: Bell crank type with servo saver
Warranty Period: Two year limited

INCLUDES: 1/8 scale Hot Bodies off-road Buggy Kit, foam air filter, body, wheels, 16 tooth clutch bell, 48 tooth spur gear, instructions and decal sheet
REQUIRES: Radio: 2-Channel with 2 Servos (one high torque servo for steering)
Radio Batteries: (8) AA size
Receiver Pack: 6V hump
Engine: .21 cu in (3.4cc) rear exhaust
Exhaust: Tuned pipe
Tires: 1/8 scale off-road buggy
Glow Starter: 1.2 volt
Paint: Polycarbonate for body
Misc. Items: Fuel bottle, building and track equipment
Fuel: 2-cycle glow fuel with 10%-15% nitromethane, 16% lubricant- Most of the fuels we carry meet or exceed the lubricant content required for optimum performance and maximum engine life. In the past, the conventional lubricant content used in fuel was 18%. But with new advanced technologies, fuels like Red Alert and O'Donnell for example, have a better quality of lubricants even though the percentages of lubricant content are lower. These high-tech lubricants provide exceptional cooling and protection.
SPECS: Vehicle-
Length: 19.7" (500mm) from front bumper to end of rear wing
Width: 12" (305mm)
Weight: 7.5lbs (3402g) approximately
Wheelbase: 12.8 - 12.9" (325 - 328mm) wheels on-center front-to-rear
Gear Ratio: 4.3:1
Body-
Length: 14.6" (371mm)
Width: 7.5" (190mm) at middle section (widest point)
1.4" (35mm) ahead of front wheels (thinnest point)
Height: 3.4" (86mm)

COMMENTS: For Replacement Ball Bearings use:
Qty. Size Location Qty. Bearing Set
2 6x10mm Steering 1 DTXC1561
6 8x16mm Diffs 3 DTXC1585
2 5x11mm Clutch 1 DTXC1547
4 8x14mm Front Hubs 2 DTXC1583
4 8x14mm Rear Hubs 2 DTXC1583